Page 1 of 1

Sources for Titanium and Stainless Steel?

Posted: Fri Nov 22, 2013 1:22 am
by Wolfman
I have only found a few sources for Titanium on the web. Titanium Goat being one, and some Ebay metal place the other. And nothing local.
I also have not had much luck on Stainless Steel also.

I am looking for Titanium and or Stainless Steel Foil, from 36 gauge (.005 mil) to 24 gauge (.020 mil) I am trying to make a Cone shaped wind screen that I can use for both my Alcohol stove or a small twig fire. I have Aluminum flashing that is about .10 or 12 gauge flashing (HD roof flashing) and it works to support the pot and use the alcohol stove, but I don't think it will work for a wood fire. Although not really sure and plan on trying it out soon. But this setup did not save me any weight from my old pot /stove holder and the windscreen, it was exactly the same weight. Complete Stove kit 15.1 oz. And they both boiled 2 cups (16 oz) in 6:30 give or take a few seconds.

I am hoping that the stainless steel would be lighter given it's a lot thinner, but if not I may have to move up to titanium. Any links or even just names would be very helpful.

Wolfman

Re: Sources for Titanium and Stainless Steel?

Posted: Fri Nov 22, 2013 11:29 am
by zelph
On ebay search for .oo4 stainless steel shim stock.

Re: Sources for Titanium and Stainless Steel?

Posted: Wed Apr 30, 2014 8:19 am
by SSGHawk
Hey Wolf,
It seems unusual that your boil times did not change since the cone shaped windscreen pot-holder forces more heat against the sides of the pot. What was your previous set up?
Regards,
Paul

Re: Sources for Titanium and Stainless Steel?

Posted: Fri May 02, 2014 8:20 pm
by zelph
Titanium Goat

Check out the photo on his home page. I thin it's in Utah. Easy to tell where you are located without a compass :D

http://www.titaniumgoat.com/